I'm gathering opinions as to whether or not I should spend the equivalent of US$280 on getting new edges cut on five Fullerton shells. This includes an 8 & 10 which now have bottom heads but no real edges. Also, the floor tom doesn't tune as well as I'd like. Lot's of money though. I am not in the USA. Thanks for your time.
Only Admins can see this message.
Data Transition still in progress. Some functionality may be limited until the process is complete.
bearing edges Last viewed: 53 minutes ago
Posts: 878
Threads: 190
Loading...
Posted on 17 years ago
#1
Posts: 22
Threads: 6
Loading...
my opinion is that you get a few more estimates. I just had bearing edges done on 13", 16", and 18" tom and floor toms...top and bottom...fiberglass shells, and it cost US$65.00. I know another guy who will do it for US$30.00 a drum. You may want to try some woodworkers in your area as well. Bearing edges are not that difficult to do. It's simple router work for a descent craftsmen. Hope this helps.
Cheers
Posted on 17 years ago
#2
- Share
- Report